Expert tip StoPox WL 213

ESD-protected areas, server rooms, battery rooms or warehouses for flammable materials - the new electrically conductive sealing system StoFloor ESD WL 213 is versatile.

The matt StoPox WL 213 water-based coating material is suitable for old and new electrically conductive epoxy resin coatings. Mineral substrates can even be subsequently upgraded to an electrostatic discharge floor.

StoFloor ESD WL 213 is a versatile and easy-to-apply sealing system. It not only works on solvent-free, electrical conductivity epoxy resin coatings, but also on mineral substrates such as concrete, cementitious screed, magnesia screed or calcium sulphate screed.

It does not require an additional conductive layer, it is sufficient to apply the floor coating twice with an earthing layer in between (StoDivers LS conducting set and StoDivers LB 100 conductive strip).

StoPox WL 213 can be applied quickly and easily without any special expertise - manually or with an airless device.

As it is sufficient to apply the floor coating twice with earthing in between (StoDivers LS conducting set and StoDivers LB 100 conductive strip), even non-conductive standard floors can be easily converted into ESD floors.

This means that StoFloor ESD WL 213 is also ideal for refurbishment.

StoFloor ESD WL 213 has a matt surface.

It is easy to clean and the high colour retention against the effects of light reduces yellowing or fading.

The surface is also abrasion-resistant, chemically resistant and plasticiser-resistant.

The low VOC content lacquer StoPox WL 213 is free from silicones, nonylphenol and benzyl alcohol.

The low VOC content lacquer StoPox WL 213 is free from silicones, nonylphenol and benzyl alcohol.

- System resistance < 109 Ohm according to DIN EN 61340-5-1:2017-07
- Charging of persons < 100 volts in accordance with DIN EN 61340-5-1:2017-07
- Personal protection in accordance with DIN VDE 0100-410:2018.10
- Resistance to ground < 108 Ohm according to TRGS 727